Sunday, January 27, 2019

Valve wipe pattern

Here it is finally.


Here is a quick video of my valve wipe pattern.
It was a simple setup, and this was for the camshaft that I plan on running, the
RacerBrown 325-R-108
It does look like it runs a bit off the backside, but it doesn't. Also this was done with zero lash, so when I set the lash to .005 and .007 it will not be as close to the end.
Also note, that the lash caps are being hit in the center, and that is pretty good because they are .175. It was recommended to go with .160 lash caps.

I will do one other camshaft, but I am not sure if I will include the wipe pattern with the next one in the video.

4 comments:

  1. Thanks for sharing the best information and suggestions, I love your content, and they are very nice and very useful to us. If you are looking for the best Industrial Valve,then NTGD VALVE.I appreciate the work you have put into this.

    ReplyDelete
  2. Your blog is awfully appealing. I am contented with your post. I regularly read your blog and its very helpful. If you are looking for the best Dual Disc check valve manufacturer in USA, then visit Valves Only. Thanks! I enjoyed this blog post.

    ReplyDelete
  3. Hi there to everyone, the contents present at this web page are actually amazing for people knowledge, well, you can also visit Stainless Steel Heat Exchanger Tubes suppliers for more Oshwin Overseas related information and knowledge. Keep up the good work.

    ReplyDelete
  4. Thanks for shared that blog with us. If anyone here searching Stainless Steel 316 Bolts then visit VIHA STEEL & FORGING.

    ReplyDelete